stockton

ventura

san diego

san luis obispo

visalia/tulare

santa maria

sacramento

santa barbara

imperial co

susanville

inland empire

palm springs

redding

chico

yuba/sutter

mendocino co

modesto

gold country

siskiyou co

bakersfield

humboldt

orange co

merced

SF bay area

los angeles

fresno

hanford

monterey

Barber

Lineman

Pipeline Welder

Welder

Motorcycle Mechanic

Iron Worker

Elevator Mechanic

Electrician

Plumber

Heavy Equipment Operator

Well Driller

Timber Framer

Stone Mason

HVAC Technician

Airplane Mechanic

Carpenter

Diesel Mechanic

Blacksmith

There are specializations within the trade.

Fairly low startup but does require a shop.

Tongs are made of three pieces of metal — two long side pieces that work similar to the side pieces in a pair of scissors and a rivet that holds the side pieces together and allows them to pivot. In each side piece, there are three segments — the jaw, the boss, and the rein.

Drifts are rather like short punches. Made of carbon-tool steel, they are of exact size and shape and may be round, hexagonal, octagonal or almost any other shape. They are usually hammered through the work to finish a hole to size and shape while the metal is only at a dull red heat. A little grease can be applied to make the work easier and to give a better finish

A flatter looks like a strange square hammer, but is really a tool that is held on the iron and struck with a hammer. It is used to smooth out bumps and hammer marks from the finished iron.

Forge is a primary source of heating metal used in blacksmithing. It’s used by the blacksmith to heat a metal piece to a temperature where it becomes easier to form by forging, or to the point where work hardening no longer happen.

It only requires fuel and heat, and that fuel can either be from propane or coal. Coal once fueled all of the earlier forges, and many still use this method as it gives heat promptly. A forge can now be fueled by propane, which is cleaner and relatively inexpensive.

An anvil is a metalworking tool consisting of a large block of metal (usually forged or cast steel), with a flattened top surface, upon which another object is struck (or "worked").

A cross peen hammer is a hammer used by blacksmiths to complete metal work. The wedge-shaped end of the hammer allows you to make the metal fuller when used with heat. The main functions of a cross peen hammer is forging and riveting.

Becoming a Blacksmith in Stockton, California

Overview

What Blacksmiths Love About Their Trade

Characteristics

Outlook

Cities With The Highest Paying Blacksmith Jobs In California

Check Out Other Trades In Stockton, California